Commissioning - Mettler Toledo InTap Portable oDO Guide De L'utilisateur

6

Commissioning

The InTap is supplied ready for use. After switching on, you can immediately use the InTap as
a measuring device or as a measuring device with data logging function.
At the factory the data logging is set to automatic mode. Use the parameter "Logging Mode" to
change to manual mode (CAL \ CONFIG \ Measurement Mode).
Note that with factory settings, the display is switched off after some minutes, but the measure-
ment will continue. Use the menu "Display Setup" to change the settings (CAL \ CONFIG \ Dis-
play Setup).
For communication with an In-Line sensor (process calibration) a separate Bluetooth interface
T100 (order number 30
to be paired with the InTap.
Pairing InTap with In-Line Sensors
Prerequisite
• The In-Line sensor is within the Bluetooth range of the InTap.
MP – Select
New MP
1
New BT device recognized 00
2 MP_01
3 MP_02
4 MP_03
InTap Portable oDO Analyzer • 30 461 735 B
432 819) has to be mounted onto each sensor and the sensor has
1
2
Edit
Edit
3
Edit
MP_01 is selected.
4
A new Bluetooth device is within the Bluetooth
range and was recognized. The sensor needs to be
parametrized.
The In-Line sensor "MP_01" is selected. The
sensor is within the Bluetooth range and already
parameterized.
The In-Line sensor "MP_02" is not selected. The
sensor is within the Bluetooth range and already
parameterized.
The In-Line sensor "MP_03" is not selected. The
sensor is already parameterized but not within the
Bluetooth range.
53 en