Time Breack Recall Setting; Wall Mounting - Geemarc CLEARSOUND CL100 Mode D'emploi

Setting up
3 - Dialling mode (Tone/Pulse) settings
The Tone/Pulse switch is factory pre-set to Tone
position. In the UK,all telephone exchanges now
use Tone (T) dialing.If your phone does not dial
out, it is probably being used from an older private
switch board (PBX).In this case,the Tone/Pulse
switch must be changed to Pulse (P).
4 - Time Break Recall setting (270/100)
Your phone works with a time break recall for United
Kingdom (R=100ms). It can be switched to 270ms
for other locations or PBX's.

5 - Wall mounting

To wall-mount your telephone, turn the "clip" (located
in the base unit, just below the ear piece).
This will ensure that the handset stays firmly in
position.
8