Wsd 151 / Pud 151R Care And Maintenance - Weller WSD 151 Mode D'emploi

WSD 151/PUD 151R
6.4 Switching the standard temperature cut-off
(standard SETBACK) on/off
When the soldering tool is not in use, the temperature is
automatically reduced to the standby temperature of 150 °C (300 °F)
after 20 s.
After a period equal to three times the setback time (60 min) has
elapsed, the auto-off function is activated. The soldering tool is
switched off completely.
1. Press and hold the UP button.
2. Switch on the control unit and wait until "ON" or "OFF" appears
on the display.
3. Release the UP button on the required setting.
Note Using extremely fine soldering tips may affect the functional
reliability of the device.
Reactivating the device (setback/OFF)
Press the UP or DOWN button.
6.5 Instructions for soldering work
Carry out the soldering work in accordance with the operating
instructions of your connected soldering tool.
Coat the tin-plated soldering tip with solder when heating the iron for
the first time as this will remove any oxide films or impurities from the
soldering tip that have accumulated during storage. During pauses
between soldering and before storing the soldering iron, ensure that
the soldering tip is well-coated. Do not use aggressive fluxing
agents.
Note Always make sure that the soldering tip is seated correctly.
The control units have been adapted to hold a medium-sized
soldering tip. Discrepancies may occur if the tip is changed or a
different shaped tip is used.
7 WSD 151 / PUD 151R care and
maintenance
Dirt and foreign objects accumulated in the join between the heating
element / sensor and the soldering tip or damage to this join may
affect the accuracy of the temperature control.
9-10