Inserting The Battery; Replacing The Battery - Hama PG-350 Mode D'emploi

G Operating instruction
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or important
notes.
2. Package Contents
• Quartz Wall Clock
• 1 AA / Mignon battery
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not use the product in the immediate vicinity of heaters or other
heat sources or in direct sunlight.
• Keep this product, as all electrical products, out of the reach of
children!
• Protect the product from dirt, moisture and overheating, and only
use it in a dry environment.
• Do not use the product in areas where the use of electronic devices
is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the
risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and - markings)
and insert the batteries accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the speci ed
type.
• Before you insert the batteries, clean the battery contacts and the
polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different type or
make.
• Remove the batteries from products that are not being used for an
extended period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the
environment. They can contain toxic, environmentally harmful heavy
metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using batteries in extreme temperatures.
2
4. Getting Started

4.1 Inserting the battery

Remove the battery that was already inserted; remove the protective
lm if necessary as well as the contact interrupter and then re-insert
the battery with the correct polarity. The clock is ready for operation.

4.2 Replacing the battery

Remove and dispose of any used batteries. Insert the new battery (AA/
Mignon). Ensure that the polarity of the battery corresponds to the
symbols in the battery compartment.
5. Installation
You can mount the wall clock on a wall using the opening on the back.
Warning – Mounting Note
• Before mounting, ensure that the chosen wall is suitable for the
weight to be mounted, and make sure that there are no electrical
wires, water, gas or other lines at the installation site on the wall.
• Purchase special fastening materials from specialised dealers.
• Do not mount the product above locations where persons might
linger.
6. Operation
• Once the battery has been inserted properly, the clock will
automatically start running.
• Use the setting wheel on the back of the clock to set the time.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not
use aggressive cleaning agents. Make sure that water does not get into
the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of
the product or from failure to observe the operating instructions and/
or safety notes.
9. Technical Data
Quartz Wall Clock
Power supply 1.5 V
1 x AA battery (alkaline)
a