positioning the peg on the facepiece into the notch at
stems through until they are seated and secured.
NOTE: Conduct a negative pressure user seal
check to ensure exhalation valve is functioning
properly.
CLEANING AND DISINFECTION
Cleaning is recommended after each use.
used to wipe the face seal of the product.
necessary
a solution of quaternary ammonia disinfectant or
sodium hypochlorite or other disinfectant. Rinse in
clean, warm water and air dry at room temperature in a
parts until facepiece is completely dry.
CAUTION
other oils on these products.
STORAGE AND TRANSPORTATION
product. When stored as stated, the expected shelf life
\ Temperature Range
]
@
: Name and address of Manufacturer
J
and the arrow will point to the month of manufacture in
their month and year of manufacture
TECHNICAL SPECIFICATION
When used with the following 3M equipment, this
up to:
P1 Particulate Filters
P3 Particulate Filters
Filters
Filters
Filters
These products meet the requirements of the European
108
Maximum Exposure
Limitations
Contact 3M for
additional information.