Using "2006" To Enter The Secure Parameters - Adam AE 402 Notice Utilisation

The parameters available are:
"F4 Int"
"F5 rEZ"
"F6 SCS"
"F7 Cnt"
"F8 Zem"
"F9 Lvd"
"FA AZn"
"Fb FPS"
The description of the parameters is shown in section 12.3

12.2 USING "2006" TO ENTER THE SECURE PARAMETERS

Press the [Z/T] key during the display counting when turned on,
When "Pn " is displayed, enter the number 2006 using the [Unit/] and [Pcs/]
keys and then press [Z/T].
"CAL".
To select another parameter press the [Pcs/] key to advance through the
parameters.
Press the [Z/T] key to enter a parameter.
To exit a parameter, press the [Print/M+/Esc] key.
The display will show the parameter number and a name.
When a parameter is entered by pressing the [Z/T] key, the displays will guide you
through the parameter selected and the options available.
The parameters available are:
"F1 CAL"
"F2 dEC"
"F3 CAP"
"F4 Int"
"F5 rEZ"
"F6 SCS"
"F7 Cnt"
"F8 Zem"
"F9 Lvd"
"FA AZn"
"Fb FPS"
Initial Zero Range
Re-Zero range
Successive Tare Enable
Display the A/D counts
Zero Mode
Low voltage detection
Auto Zero Range
User Function Password
The displays will show the first parameters, called "F1"
To enter the Calibration
Decimal Point Position
Default Weighing Unit and capacity
Initial Zero Range
Re-Zero range
Successive Tare Enable
Display the A/D counts
Zero Mode
Low voltage detection
Auto Zero Range
User Function Password
© Adam Equipment Company 2010