User Parameters; Check Weighing Parameters - Adam AE 402 Notice Utilisation

7.0 USER PARAMETERS

Pressing the [Func/C] key during normal operation allows the user to access the
parameters for customizing the scale. The parameters are split into 4 groups-

1. Check weighing parameters,

2. Percent and Animal Weighing Functions
3. RS-232 parameters and
4. Scale parameters
• When [Func/C] is pressed, display will first show "FunC 1" for Check weighing
parameters.
• Press either the [Func/C] key or the [Pcs/] to advance through the groups
"FunC 1", "FunC 2" , "FunC 3" and "FunC 4". Press [Z/T] to enter the desired
group of parameters.
• When in one of the sections press [Print/M+/Esc] to return to the group
"FunC 1". If you press [Print/M+/Esc] again, the scale will exit the User
Parameter section and return to normal weighing.
7.1 CHECK WEIGHING PARAMETERS
• Press [Z/T] to enter the group.
• Use the [Unit/] key and [Pcs/] key to set the values or just the [Pcs/]
key to select the options.
• Press [Z/T] to confirm the change and then advance to the next parameter by
pressing the [Pcs/] key.
This group of parameters-
- Set low and high limits for check-weighing
- Enables or disables the check weighing alarm
- Enables or disables the negative check weighing
© Adam Equipment Company 2010