6.0 OPERATION
6.1
ZEROING THE DISPLAY
• You can press the [Z/T] key at any time to set the zero point. This will
usually be necessary when the platform is empty. When the zero point
is obtained the display will show an indicator for zero.
• The scale has an automatic re-zeroing function to account for minor
drifting or accumulation of material on the platform. However you may
need to press the [Z/T] key to rezero the scale if small amounts of
weight are shown when the platform is empty.
6.2
TARING
• Zero the scale by pressing the [Z/T] key if necessary. The "ZERO"
indicator will be ON.
• Place a container on the platform, a value for its weight will be
displayed.
© Adam Equipment Company 2010