golmar VistaPlus Manuel D'installation page 104

DOOR PANEL INSTALLATION
A
ssembling the EL500/R5 microprocessed circuit and the EL516SE
push buttons encoders.
The EL500/R5 circuit is to be assembled on the top of the
embedding box Insert the circuit in the
the embedding box (1) Push-in the
flanges (2) by pressing
Insert the sound module in the grille module.
.
. circuit in the bottom
the pcb board .
To assemble the EL516SE encoder, screw the top tab of the
case to the corresponding plastic lug of the embedding
box .
Place the circuit on the lower flanges and screw it into
the embedding box
In case of more than one encoder, place them underneath
or in the next embedding box
The use of EL516SE encoders is only necessary for panels
with more than 8 push buttons
Each encoder allows to connect 15 push buttons,
obtaining a maximum of 120 push buttons by using 8
encoders .
A
ssembly of the sound
For a proper assembly, align the light push
button and the microphone rubber of the
sound module with its corresponding holes
in the grille module.
top flanges of
2
.
.
.
103
module.
1