Beta 1837C/2100 Notice D'utilisation Et Instructions page 6

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
LED SPOTLIGHT SAFETY INSTRUCTIONS
- To charge the spotlight, connect the power supply to the mains socket, making sure that the mains
voltage matches the one stated on the power supply device. (See TECHNICAL DATA table)
- Do not subject the spotlight to voltage overcharge; always check it for damage.
- When not in use, store the spotlight out of the reach of children and any people who are unfamiliar
with these instructions.
- Do not modify the lamp. This can reduce the effectiveness of safety measures and increase operator
risk.
- To clean the spotlight, use a dry cloth and always disconnect the power supply from the spotlight.
TECHNICAL DATA
CHARGING VOLTAGE (POWER SUPPLY)
INTERNAL BATTERY
LED LAMP (COB type)
OPERATING TIME
CHARGING TIME
HEIGHT
WIDTH
DEPTH
INDEX OF PROTECTION
SHOCK RESISTANCE
OPERATING TEMPERATURE
WEIGHT
USE
- Turn on the spotlight by pressing the ON/OFF switch on the rear panel.
- Press the ON/OFF switch to change the luminous intensity of the spotlight : ECO-NORMAL-MAXI-
MUM mode.
- The spotlight is fitted with a swivel base for use on Beta's item 1837S.
CHARGING
- To charge the spotlight, connect the power supply to the mains socket, making sure that the mains
voltage matches the one stated in the TECHNICAL DATA table.
- Before the first use, with the spotlight stored in the warehouse, the charging time is approximately
4-5 h.
- While the spotlight is being charged, it must be off.
-While the spotlight is being charged, the battery indicator will be blinking. When charge is completed,
all the battery indicators will remain on.
- If the battery indicator does not light up, remove the battery charger and try again.
- To charge the spotlight, only use the recommended battery charger.
CAUTION
Do not direct the LED light beam at people or animals: this may cause temporary blinding.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can
contact Beta Utensili S.P.A.'s repair centre.
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be
collected separately from other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
• deliver it to an appropriate collection facility for electronic and electrotechnical equipment;
6
DC 15V – 1.5A
LI-ION 11.1V; 4400mAh; 48.84Wh
500/1000/2100 Lumen
9h / 5h / 2h 30 min
3h 30 min
225 mm
200 mm
70 mm
IP65
IK07
-10°C ÷ 40°C
1.150 kg
EN I