Addition Of Individual Weighings - KERN VHB Mode D'emploi

7.5 Addition of individual weighings

The display unit offers an option that allows the addition of weighings and the display
of the total weight. When the tare weight is active, the net weight is automatically
added up.
Loading the system with the load to be added

To add the weighed weight to the memory, press the

The displayed value is stored and simultaneously added to the summation

memory.
The display alternately shows consecutive numbers (number of weighings) and

the total value (summation memory).
If the weighing system has been equipped with a printer, the value shown is

printed at the same time (KERN VHS).
After a few seconds the system automatically reverts to standard weighing

mode.
or
To read the total weight calculated so far, press the

The display alternately shows the consecutive numbers (number of weighings)

and the total.
After a few seconds the system automatically reverts to standard weighing

mode.
Whilst the total value is displayed, you may delete the memory by pressing the

TOTAL
key.
If the system is equipped with a printer, an overview print is made (KERN VHS)

The display shows the sequence number 00 and the initial value 0.0 kg.

The system automatically reverts to standard weighing mode.

Important:
Please note that the balance must be unloaded between the individual weighing

procedures.
Additional summation is also possible after the scales were turned on or off. The

stored values are kept after the scales were turned off.
VHB/VHS-BA-e-1613
TOTAL
key.
TOTAL
key for three seconds.
13