Sony Ericsson UP-DR100 Mode D'emploi page 39

Note
Be sure to remove all of the seals attached to the
paper roll. A seal remaining inside the printer may
cause problems.
5
Close the cover.
Confirm that the tip of the paper appears.
If the tip of the paper protrudes from the platen
roller, be sure to insert the tip of the paper under the
rollers.
Rollers
Note
Do not touch the printing surface of the paper roll
in the paper holder after loading it. Sweat or dust
from your hands may cause a deterioration in the
quality of the printout.
6
7
Platen roller
Hold both spools and push the blue spool into the
blue spool holders.
Insert the left side of the blue spool first,
then the right side and push it until it clicks.
Caution
Since the thermal head is still very hot just after
printing is finished, be careful not to touch the
thermal head when loading the ink ribbon.
Detach the pink spool from the blue spool. Pull it
upward and wind it until the transparent part (the
laminating part) comes to the position illustrated,
and push it into the pink spool holders.
Insert the left side of the pink spool first,
then the right side and push it until it clicks.
The black marks should show on
the front of the pink spool.
Transparent part (the laminating
part)
Loading the Paper and Ink Ribbon
39