Dip Switch Settings; Scsi Id Setting - Sony Ericsson UP-DR100 Mode D'emploi

DIP Switch Settings

Set the SCSI ID with the DIP switches on the side panel.
The DIP switches are set as follows when shipped from
the factory.
Terminator
Terminator ON/OFF Setting
When the printer is connected as the terminating device
on the SCSI bus, set the terminator to the ON position.
Otherwise, set it to the OFF position.
Switch ON
TERMINATOR Internal Terminator
ON

SCSI ID Setting

Set the printer SCSI ID so that it is different from all
other devices on the SCSI bus.
If two devices have the same SCSI ID, malfunctions
may result.
SCSI ID SCSI ID Switch
1
0 0
1 1
2 0
3 1
4 0
5 1
6 0
7 1
The SCSI ID is set to 1 as the factory setting.
SCSI ID
OFF
Internal Terminator
OFF
2 4
0 0
0 0
2 0
2 0
0 4
0 4
2 4
2 4
35
DIP Switch Settings