Sony Ericsson UP-DR100 Mode D'emploi page 38

1
Pull the top of the front door to open it.
2
Pull the cover up.
3
After removing the labels attached at both sides of
the paper roll, place the paper roll in the paper
holder.
Place the paper roll in the paper holder, so the pink
flange is on the right and the blue flange is on the
left.
38
Loading the Paper and Ink Ribbon
Remove the labels.
Load the paper after matching the colors of the
flange of the paper roll and the flange holder of
the printer correctly.
Caution
Since the thermal head is still very hot just after
printing is finished, be careful not to touch the
thermal head when placing the paper roll in the
paper holder.
4
Remove the label attached at the tip of the paper,
then, while holding both ends of the paper, insert
the paper into to the slot. Feed in the paper with
your hand until the marking hole appears.
Roll the paper in properly so that it goes
in straight.
Thermal head
Marking hole