Error And Warning Messages - Sony Ericsson UP-DR100 Mode D'emploi

SCSI-2 Interface
Connectors Two 50-pin, half-pitch
Terminator Internal (DIP switch enable/disable)
SCSI ID setting 0 to 7 (DIP switch selectable)
Transfer speed Max. 10 MB/sec (Fast SCSI)
Design and specifications are subject to change without
notice.
52

Error and Warning Messages

Error and Warning
Messages
Error and warning messages appear on the information
display under the following conditions. Please take the
remedial actions shown next to the message to correct
the condition.
Error messages
When a problem occurs, the ALARM indicator on the
front panel lights in red, and an error message appears
on the information display. Please take the remedial
actions shown next to the message to correct the
condition.
Message Description and Remedy
DOOR OPEN The front door is open.
tClose the front panel until it is
locked securely (page 40).
FEED ERROR Paper cannot be fed or ejected
correctly.
tLoad the paper roll correctly.
(page 43)
MECHA TROUBLE • The ink ribbon may break.
tRepair it with adhesive tape.
• The paper corresponding to the
designated number of sheets is
exhausted.
tLoad a new ink ribbon and paper
• The ink ribbon corresponding to the
designated number of sheets is
exhausted.
tLoad a new ink ribbon and paper
• Mechanical trouble has occurred in
the printer.
tThe ink ribbon and paper roll are
tIf the message does not
MEDIA MISMATCH An incompatible ink ribbon and paper
are loaded.
tLoad the compatible ink ribbon and
paper roll taken from the same
package. (page 51)
NO PAPER The paper roll is not loaded.
tLoad paper roll.(page 37)
NO RIBBON The ink ribbon is not loaded.
tLoad an ink ribbon.(page 37)
(page 41)
roll. (page 37)
roll. (page 37)
not loaded correctly. Load them
correctly. (page 37)
disappear even after performing
the above remedy. Contact your
supplier or nearest Sony Service
Center.