Dust Extraction - Storch Delta 100 Mode D'emploi

Electronic rpm regulation
The rpm can be adjusted by rotating the wheel speed adjust-
ment wheel (3) located on the rear of the tool. The choice of
speed depends on the characteristics of the abrasive paper
disc and the material to be worked.

Dust extraction

ATTENTION:
Hazardous dust can be produced during sanding operations:
Always connect an adequate extraction device.
In case of work producing dust, wear a mask.
Integrated extraction
- To guarantee optimal extraction of the powder empty the
conical filter (8) in time, accurately cleaning the filter holder
(8 a) and regularly cleaning the cartridge (8 b);
- During works on the vertical surfaces, position the machine
so the conical filter is turned downwards.
- Conical filter assembly: position the conical filter (8) on the
extractor tube coupling (4). Push the conical filter until it
stops.
- Conical filter filling testing: the filling status of the conical
filter is easily controlled using the transparent filter holder
(8 a).
- Conical filter cleaning: to empty the conical filter, remove
it from the extractor tube coupling working in the opposite
direction to assembly;
- Release the cartridge (8.b) and release it from the filter
holder;
- Empty the filter holder;
- Clean the cartridge plates with a soft brush.
Translation of the original instruction
76