Storch Delta 100 Mode D'emploi page 75

Replacement of the abrasive paper assembly:
- Press the abrasive paper into the pad (10) ensuring that the
holes in the paper coincide with extraction holes in the pad.
Disassembly:
- Used abrasive paper can be removed by simply tearing them
off;
- new velcro abrasive paper it's mounted (see "Assembly")
Sanding pad replacement
Replace damaged sanding pad immediately. Opti-
mal results are achieved only using original accessories.The
assembly of a sanding pad with incorrect dimensions can cau-
se excessive vibrations which are not allowed for the machine.
- Unscrew the screws (7) on the pad;
- reverse the procedure when fitting the pad.
Start the tool and check that there are no unusual vibration,
no dismatching movement of the abrasive disc. Otherwise
switch-off the tool immediately and eliminate the cause.
Starting and stopping
- Starting: press the switch (2) down in position "ON".
- Stopping: press the switch (2) up in position "OFF".
WARNING:
after an interruption of the electrical energy, if the ON/OFF
switch is inserted, it is necessary to release the switch (see
Stopped).
Translation of the original instruction
75