Disposal And Recycling - STERWINS EDWC-3 Mode D'emploi

c) Electronic card fault:
Switch the pump unit off and back on, The pump unit should start. Else, check with our
Technical Support for the electronic card to be replaced.
d) Not electrical supply:
Check the proper electric feeding. The tension LED (POWER) should be on.
e) Pump pressure low:
The safety device has tripped and the respective indicator LED (FAILURE) is on.
Make sure that the pump pressure is at least 0.5bar. higher than the starting pressure of the
EDWC-3, EDWC FR-3.
3. The pump starts and stops repeatedly:
a) Small leak in some point of the installation:
Verify possible tap or WC tank leaks and repair them.

DISPOSAL AND RECYCLING

This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe recycling.
EN
60
GUARANTEE
1. STERWINS products are designed to highest DIY quality standards. STERWINS offer a 36-month
warranty for its products, from the date of purchase. This warranty applies to all material and
manufacturing defects which may arise. Further claims of any nature, whether direct or
indirect, with regard to persons and/or materials, are not possible.
2. In the event of a problem or defect, you should first always consult your STERWINS dealer. In
most cases, the STERWINS dealer will be able to solve the problem or correct the defect.
3. Repairs or the replacement of parts will not extend the original warranty period.
4. Defects which have arisen as a result of improper use or wear are not covered by the warranty.
Amongst other things, this relates to switches, protective circuit switches and motors, in the
event of wear.
5. Your claim upon the warranty can only be processed if:
Proof of the purchase date can be provided in the form of a receipt
No repairs and/or replacements have been carried out by third parties
The appliance has not been subjected to improper use (overloading of the machine or fitting
non-approved accessories).
There is no damage caused by external influences or foreign bodies such as sand or stones.
There is no damage caused by non-observance of the safety instructions and the instructions
for use.
6. The warranty stipulations apply in combination with our terms of sale and delivery.
7. Faulty tools to be returned to STERWINS via your STERWINS dealer will be collected by
STERWINS as long as the product is properly packaged. If faulty goods are sent directly to
STERWINS by the consumer, STERWINS will only be able to process these goods if the consumer
pays the shipping costs.
8. Products which are delivered in a poorly packaged condition will not be accepted by STERWINS.
61
EN