Turning On The Appliance; Steam Ironing - Rotel PROFESSIONAL PLUS Mode D'emploi

Turning on the Appliance

- Position the appliance on a level and stable surface.
- Before you connect the appliance to the power supply, please check whether the data specified on the type
plate corresponds to your power supply voltage, and then set the switch (7) to "ON."
- The illuminated control light (5) indicates that the iron is heating up.
- Wait 4 - 5 minutes, until the control light goes out.
- The iron is now ready-for-use.

Steam Ironing

You can steam-iron using either STEAM JETS or CONTINUOUS STEAM GENERATION.
- To iron using steam jets, press the steam button (4, Fig. C), exerting more or less pressure to regulate
the desired steam rate.
- Should you wish to use the maximum steam intensity, completely depress the steam button. The steam
flow will always remain constant, and in proportion to the pressure you exert.
- To obtain continuous steam generation, turn the steam regulator (2, Fig. D) clockwise as shown in the
diagram. You thus obtain a uniform and continuous flow of steam, which is the most intense, when the
steam regulator is completely turned.
- You can also increase the steam jet during continuous steam generation by pressing the steam button
(4).
- No matter whether you are ironing using the steam jet function or with continuous steam, never turn the
iron upside down, nor tilt it too far to the fore or side.
It must be emphasized that steam is also generated in the automatic mode during short interruptions in ironing,
e.g., when you are preparing the next garment to be ironed or you briefly switch off the ROTEL
PROFESSIONAL. However, if you take into consideration just how easily steam is generated manually, it is
advisable to avoid automatic steam output, and thereby save energy and steam.
You will achieve the best ironing results by categorically turning off the steam button and, when
necessary, trigger a super steam burst by lightly pressing the steam button. When ironing, NEVER use
continuous steam or uninterrupted super steam bursts the whole time, because your laundry will
otherwise become too wet and the steam supply is exhausted.
When setting down the ROTEL PROFESSIONALplus***** there is a risk of it slipping!
When the water volume has completely evaporated, no more steam will be emitted. .
Caution!
Before setting down the iron, always switch off the steam flow.
NEVER OPEN THE SAFETY CAP (1) DURING USAGE. FIRST SET THE SWITCH (7) TO "0" BEFORE
OPENING THE SAFETY CAP. SUBSEQUENTLY, PULL THE POWER PLUG OUT OF THE SOCKET AND
THEN RELEASE THE PRESSURE IN THE IRON BY PRESSING THE STEAM BUTTON (4).
Filling with Water during Ironing
Caution!
Always turn the appliance off and pull the power plug out of the socket before filling the boiler with water.
Should you need to refill the iron when ironing, please proceed as follows:
- Set the switch (7) to "0."
- Pull the power plug out of the socket.
- Completely depress the steam button (4) and discharge the steam pressure in the interior.
- Remove the safety cap (1) on the boiler. Use the cap screw provided (3) to facilitate its removal. The cap
screw provides for a better grip on the safety cap and protects you from inadvertent burns.
- Pour a small amount of water into the boiler 2 or 3 times to discharge the steam in the boiler.
Subsequently refill the boiler as normal.