Intended Use; Turning On The Appliance - Rotel profplus U980CH1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 INTENDED USE
o
You can use your ROTEL STEAMIRONPROFPLUS980CH1 to either dry or steam-iron
all types of clothing, curtains and fabrics (even when hung on a clothes hanger).
When ironing, follow the instructions indicated on the label. We recommend
ironing on a stable and absorbent surface. This holds true for both positioning the
fabrics, as well as setting down the iron to get another garment. The appliance is
only intended for private use and is thus not suitable for industrial or commercial
purposes. The manufacturer has not intended that this appliance be used for any
other purpose. The manufacturer does not accept any liability for damages arising
from unintended use of this appliance. All warranty rights shall be forfeited in cases
of unintended use.
 FILLING THE BOILER WITH WATER PRIOR TO USE
o
Caution! Unplug the iron before you fill it with water.
o
Place the iron in a horizontal position, and fill the boiler using
the measuring cup (12) and funnel (11) provided (Fig. B).
o
NEVER FILL IT WITH MORE THAN 300 ml WATER. This amount
corresponds to the quantity indicated on the measuring cup. If
too much water is added, when you start to iron water will
either leak or be sprayed out of the steam holes.
o
Do not use any chemical additives and fragrances.
o
Empty the boiler after use.
 PREPARING TO USE YOUR IRON
o
The safety cap (1) must be properly secured. However, do not screw it on too
tightly. NEVER TIGHTEN IT USING THE CAP SCREW (3). Only turn the safety cap as
far as it will go. Screwing it on too tightly could damage the seal and steam would
emit from the safety cap.
o
It is imperative that you use an absorbent ironing pad.
 TURNING ON THE APPLIANCE
o
Position the appliance on a level and stable surface.
o
Before you connect the appliance to the power supply, please check whether the
data specified on the type plate corresponds to your power supply voltage, and
then set the switch (7) to "ON."
o
The illuminated control light (5) indicates that the iron is heating up.
o
Wait 4 - 5 minutes, until the control light goes out.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Profplus u980ch2

Table des Matières