Technical Data; Directions For Use - Rotel PROFESSIONAL PLUS Mode D'emploi

PRODUCT DESCRIPTION (FIG. A)
1 Safety cap
2 Steam regulator
3 Cap screw
4 Steam button
5 Control light
6 Power cord
7 ON/OFF switch
8 Soleplate
9 Boiler
10 Power rating plate (type plate)
11 Funnel
12 Measuring cup

TECHNICAL DATA

Model
Performance
Tank volume
Boiler pressure
Maximum pressure
Weight
Dimensions L/W/H

DIRECTIONS FOR USE

Caution!
Before using the appliance for the first time, remove any labels or protective films that might be on the soleplate.
Filling the Boiler with Water Prior to Use
Caution!
Unplug the iron before you fill it with water.
- Place the iron in a horizontal position, and fill the boiler using the measuring cup (12) and
funnel (11) provided (Fig. B).
- NEVER FILL IT WITH MORE THAN 300 ml WATER. This amount corresponds to the
quantity indicated on the measuring cup. If too much water is added, when you start to iron
water will either leak or be sprayed out of the steam holes.
- Do not use any chemical additives and fragrances.
- Empty the boiler after use.
Preparing to Use Your Iron
The safety cap (1) must be properly secured. However, do not screw it on too tightly. NEVER TIGHTEN IT
USING THE CAP SCREW (3). Only turn the safety cap as far as it will go. Screwing it on too tightly could
damage the seal and steam would emit from the safety cap.
It is imperative that you use an absorbent ironing pad.
U98.0
800 W / 230 V - 50 Hz
300 ml
3 – 3.5 bar (operating pressure)
5 – 5-5 bar
1.7 Kg
27 x 12 x 14 cm