Important Safety Instructions; Grounding Instructions - NSS WRANGLER 2016 AE Instructions D'origine

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
conductor can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether the outlet
is properly grounded. Do not modify the plug provided with the
machine. If outlet is not suitable for safe use, have a proper outlet
installed by a qualified electrician.
Always use a properly grounded 3-wire extension cord which has
male and female plugs. If 25 ft [7.6m] extension cords are used, the
electrical carrying capacity should be no less than 14-3 ST. 50 ft
[15.2m] extension cords no less than 12-3 ST.

GROUNDING INSTRUCTIONS

This machine shall be grounded while in use to protect the operator from electric shock. The machine is provided
with a three-conductor cord and a three-contact grounding type attachment plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
The green conductor in the cord is the ground wire. Never connect this wire to other than the grounding pin of the
attachment plug.
Check nameplate on the machine to be sure voltage and cycle stated is the same as the electrical outlet. Do not
attempt to plug a 120 volt machine into a 240 volt outlet or a 240 volt machine into a 120 volt outlet. If the
machine is provided with an attachment plug as shown in Figure A below, it is intended for use on a nominal 120
volt circuit. If a properly grounded receptacle as shown in Figure A is not available, an adapter may be installed
as shown in Figure B if the outlet box that houses the receptacle is grounded. Be sure to fasten the grounding tab
(the green colored rigid ear, lug or the like extending from the adapter) with a metal faceplate screw.
If the machine is provided with an attachment plug as shown in Figure C, it is intended for use on a nominal 240
volt circuit. Changes to the attachment plug or use of adaptors to other plug types must be done in accordance
with local regulations.
NOTE: In Canada, the use of a temporary adaptor may not be permitted by Canadian electrical code.
ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR/
SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS.
GROUNDING OF ELECTRICAL EQUIPMENT
Improper connection of the equipment–grounding
SAVE THESE INSTRUCTIONS