dji RONIN 2 Guide De Démarrage Rapide page 8

Powering on and Activating the Ronin 2
A. Insert the Intelligent Batteries into the battery mount until the battery's Eject buttons are engaged.
B. Attach the battery mount to the gimbal until the Release button is engaged.
C. Make sure you unlock the pan, tilt, and roll axis before powering on the Ronin 2. Press and hold the
Power button on the gimbal or battery mount to turn on the Ronin 2.
D. On your mobile device, switch on Bluetooth and launch the Ronin App. With a secure internet
connection, follow the onscreen instructions to activate Ronin 2 for the first time.
Built-in Touch Panel Settings
A. Press the Mounting Mode Button to select a mounting mode. The
screen will display Handheld
Tripod mode .
B. Press the Follow Mode Button to select a follow mode. The screen
will display Lock , Follow
C. Enter the Motor settings page and select Auto Tune. You can also
manually adjust the Stiffness. Strength, Filter, and Control values
are advanced settings and should only be adjusted with proper
knowledge.
D. Enter the SmoothTrack settings page to adjust Speed, Deadband,
and Acceleration values for the pan, tilt, and roll axes separately.
E. Enter the Remote settings page to adjust Deadband, Max Speed,
and Smoothing values, for the pan, tilt, and roll axes individually
and assign them to the remote controller.
F. Enter the Settings page to adjust Bind Remote, Remote Frequency
Band, Speaker, and Axis Mode. The Bluetooth password is
available via the "More" tab.
: Bluetooth Connection Status
: Remote Controller Signal
Strength
: GPS Signal
12
: Motor Pause Mode
: Axis Mode
: Working Battery Number
: Battery Level
, Car Mount , Aerial
, FPV or Recenter mode
12 2 12
60%
0º
Motor SmoothTrack
Pan
Basic More
Stiffness
SmoothTrack
Pan Tilt Roll ON
6 10
10
Power 0 -6 -2
Speed
20
Atti Err
1.9 0.6 0.1
Atti
0.02 -0.66 -0.15
Auto tune
RONIN 2 Quick Start Guide
1
or
.
0º
3
5
7
1. Mounting Mode Button
2. Follow Mode Button
3. Back Button
4. Toggle Button
5. Jog Wheel
6. OK Button
7. Lock Button
8. Motor Pause Button
2 12
60%
0º 0º
Remote
Motion
Tilt Roll
Pan
Push Pan
OFF Deadband Max Speed Smoothing
10 50
Deadband Accel
Left Right
5 20
0 0
Test Endpoint
©
2017 DJI OSMO All Rights Reserved.
2
4
6
8
2 12 2
60% 60%
0º
Settings
Channel
General Profile More
Calibrate System
15 Bind Remote Remote Freq.
Start 2.4Hz
Speaker Axis Mode
ON 3-axis
7