Reversing Doors - Tripp-Lite SmartRack SR42UBCL Guide D'utilisation

5. Enclosure Configuration

5.2 Reversing Doors

1
Remove the screw connecting the ground wire to the inside of the door.
2
Remove the combination lock, cam and screw plate from the door of the enclosure as shown.
3
Remove the doors by following the steps in the previous section.
4
Remove the door hinges from the enclosure, rotate them 180 degrees and attach them on the opposite side
of the enclosure. Note: The alternate door hinge attachment points have plastic plugs in the screw holes.
Remove the plugs and insert them in the original door hinge attachment points.
5
Unscrew the 2 hinge mechanisms from the hinge openings inside the door, then reattach each of them using
the set of screw holes immediately opposite their original position.
6
Rotate the door 180 degrees and reinstall it on the enclosure. Remember to connect the ground wire to the
inside of the door, using the attachment point nearest the hinge at the top of the door. The attachment point
is marked with the ground connection symbol:
( continued )
.
7
1
2
3
4
5
6