Adding Or Removing Roof Panel; Removing Roof Panel; Reinstalling Roof Panel; Adding Or Removing Side Panels - Tripp-Lite SmartRack SR42UBCL Guide D'utilisation

5. Enclosure Configuration
5.2 Reversing Front Doors
7
Reinstall the combination lock, so the unit is right-side up. Slide the lock handle through the opening, install
the cam, and then secure the lock using the screws and screw plate as shown.

5.3 Adding or Removing Roof Panel

WARNING: Do not attempt to use the roof panel for weight-bearing purposes other than those explicitly described and approved by Tripp Lite. Do not attempt
to add or remove the roof panel without assistance.

5.3.1 Removing Roof Panel

1 Pull the 2 pins near the rear of the roof panel. While holding the pins, push the roof panel upward.
2 A
Remove the roof panel tabs
3
Lift the roof panel from the enclosure.

5.3.2 Reinstalling Roof Panel

To Reinstall Roof Panel, Reverse Steps 1-3

5.4 Adding or Removing Side Panels

5.4.1 Removing Side Panel

1
Open the latch by sliding it downward.
( continued )
( continued )
from the roof panel attachment slots
B
in the enclosure frame.
8
7
2
1
A
B
2
3
1
1