Placement; Leveling - Tripp-Lite SmartRack SR42UBCL Guide D'utilisation

4. Enclosure Installation
4.2 Unpacking
( continued )
6
Position at least one person at the front of the enclosure and one person at the rear of the enclosure. Slowly
push the enclosure toward the back of the shipping pallet until all four casters go over the edge of the pallet
and touch the floor. WARNING: Use at least one assistant when removing the enclosure from the pallet.
Be extremely careful when moving the enclosure.

4.3 Placement

1
Use the casters to move the enclosure for a short distance over a level, smooth, stable surface by pushing it
from the front or rear (not the side panels). Do not attempt to roll the enclosure over long distances. The
enclosure should be moved close to its installation location inside its shipping container before it is
unpacked. (Use a forklift or pallet jack to move the shipping container.) WARNING: Do not push or pull
the enclosure at the side panels or pull the enclosure toward you.
If required, the enclosure can be lifted by attaching 4 user-supplied M8 diameter eye bolts to the threaded holes near the upper corners of the enclosure frame. Use steel
bolts with an ISO strength rating of 8.8 or higher. The 4 bolts can support the weight of the enclosure and up to 1000 lb (450 kg) of installed equipment.
WARNING: Only experienced equipment operators should attempt to lift the enclosure. Use appropriate equipment and follow all applicable safety procedures
and regulations.

4.4 Leveling

WARNING: Level the enclosure before attempting to install equipment. The casters are not designed to provide long-term support for the enclosure. Use the
levelers to provide long-term support. Install the enclosure in a structurally sound area with a level floor that is able to bear the weight of the enclosure, all
equipment that will be installed in the enclosure and any other enclosures and/or equipment that will be installed nearby.
1
After the enclosure has been moved to the installation location, use a carpenter's level to check the slope of
the floor. If the floor slopes more than 1%, choose an alternate installation site.
2
Use an 18 mm open-end wrench to lower each leveler
the front and 2 at the rear.) Make sure each leveler contacts the floor solidly. Note: Lower a leveler by
turning it clockwise; raise a leveler by turning it counter-clockwise.
3 After lowering each leveler, use the carpenter's level to confirm that the enclosure is level in all directions.
Adjust the levelers as required until the enclosure is level.
( continued )
A
until it reaches the floor. (There are 4 levelers, 2 at
5
6
1
FLOOR
1
2
3
A