Reinstalling Side Panels; Combining (Baying) Enclosures - Tripp-Lite SmartRack SR42UBCL Guide D'utilisation

5. Enclosure Configuration
5.4 Adding or Removing Side Panels
2 Tilt the top of the panel away from the enclosure.
3
Lift the panel away from the brace that supports it.

5.4.2 Reinstalling Side Panels

To Reinstall Side Panels, Reverse Steps 1-3

5.5 Combining (Baying) Enclosures

WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined enclosures requires the same stabilizing
measures as a standalone enclosure.
1
Arrange the enclosures in the correct position for baying.
2
Each enclosure includes 4 baying brackets
adjoining enclosure. The baying connection points already contain screws. Remove the screw from each
baying connection point in the adjoining enclosure.
3
Loosen the screw in each baying bracket and turn each bracket 90 degrees toward the adjoining enclosure,
aligning each bracket with the corresponding baying connection point on the adjoining enclosure.
( continued )
( continued )
A
that correspond to baying connection points
2
3
1
B
on the
2
3
9
B
A
90°