Unpacking - Tripp-Lite SmartRack SR42UBCL Guide D'utilisation

4. Enclosure Installation

4.2 Unpacking

NOTE: If the enclosure is an "SP1" model with a shock pallet, follow the special unpacking instructions attached to the shipping container instead of the
unpacking instructions in this section. All warnings still apply.
1
Confirm that the shipping container is upright and stable, then use a utility blade to cut the shrink-wrap
securing the corner protectors. Apply the utility blade directly over the corner protectors to prevent the utility
blade from scratching the enclosure or cutting the heavy protective plastic bag beneath the shrink-wrap.
WARNING: Do not scratch the enclosure or cut the heavy plastic bag beneath the shrink-wrap. Do
not push or pull the enclosure while unpacking.
2 Remove the corner protectors. Save all packing materials (including the pallet) for later use unless you are
certain they will not be required. The packing materials are recyclable.
3
Remove the heavy plastic bag surrounding the enclosure. Examine the enclosure for any damage or loose
parts. Confirm that all parts are present. If anything is missing or damaged, contact Tripp Lite for assistance.
Do not attempt to use the enclosure if it has been damaged.
4
Use the key to open the enclosure's doors and locate the 2 shipping brackets
the shipping pallet. The brackets are located inside the enclosure. Note: The keys are attached to the front of
the enclosure.
5
Use a 13 mm open-end wrench to remove the shipping brackets. Be extremely careful, as the enclosure
could shift unexpectedly after bracket removal. Save the brackets and bracket hardware for later use.
( continued )
A
that attach the enclosure to
4
1
2
3
A
4
5