Publicité
Les langues disponibles
Les langues disponibles
Fiat Croma Bumper Removal.
1. Remove the plastic rear boot plinth. (2 screws on top, 4 on inside boot wall)
2. Remove both side trim panels to gain access to two internal bumper screws and long plastic nut. (3 plastic clips
along base, luggage eye, screw at top edge.)
3. Loosen the rear of each wheel arch cover for access to bumper tip screw. (1 screw in plastic recess)
4. Remove rear light clusters to gain access to two screws securing the bumper edge. (2 bolts from inside rear
quarter cavity.)
5. Begin bumper removal by removing 2 screws from bottom edge, 1 screw at each bumper tip, 2 screws holding
top edge of bumper end and located inside rear quarter cavity, 2 screws on top edge of each corner (light
cluster area)
6. Pull each tip away from bodywork and slide bumper rearwards to remove.
7. Continue with tow bar fitment as detailed in Item 1 of main fitting instruction.
Fiat Croma Bumper
Cut.
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
witter-towbars.co.uk
W0001G78B-FIT$031103150000TÄ
W0001G78B-FIT$031103150000
VEHICLE
C L
Issue 3
Publicité
