gdw 1198 Mode D'emploi page 5

Daewoo Musso
10/1999 - ....
Ref. 1198
Fitting instructions
1) Loosen the bumper supports. Place the mounting pieces (-g) and (-h) with points (C) on the place where
the bumper supports were detached. Insert the bolts and fix the mounting pieces (-g) and (-h) with the
bumper supports. Place mounting pieces (-i) and (-j) with points (A) on the existing holes in the chassis
and with points (B) on the points (B) of the mounting pieces (-g) and (-h). Insert the bolts through the
bottom of the chassis and place the washers on top of the chassis. Do not tighten anything yet.
2) Place the tow bar in between mounting pieces (-i) and (-j), fitting points (D') and (D) on points (D) and
(D') of (-i) and (-j). Insert the bolts and tighten everything firmly.
3) Install the (*) and tighten everything firmly.
Composition
1 tow bar reference 1198
1 flange ball 50T/90
2 bolts M12-30 + nuts
4 bolts M12-130 + nuts
2 bolts M14-35 + nuts
2 bolts M14-35
2 bolts M16-50 + nuts
4 washers 40-14-4
6 safety washers 12 mm
6 safety washers 14 mm
2 safety washers 16 mm
1 security shackle 50T
1 mounting piece (-g)
1 mounting piece (-h)
1 mounting piece (-i)
1 mounting piece (-j)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(B)
(A)
(D)
(D')
(*)
(A)
(A-B)
(D)
(*)
(*)
(B-C)
(B-C)
(A-B-D)
(A-B-D)
All bolts and nuts : quality 8.8