Technical Features - Altrad BET ECOMIX 150 Manuel D'instructions

1 - PRESENTATION :
ECOMIX concrete mixers have been conceived to fully execute the hardest jobs under the worst conditions.
Its design has been studied and the materials that intervene in its manufacture chosen; in order to obtain a robust and swift set of modern
conception.
Its perfectly balanced transmission and rotation mechanisms as well as the double effect mixers surpass conventional productivity.
Our goal is to improve and make the work of the machines that we produce more efficient. For this reason we reserve the right to vary its
mechanisms, forms etc.
ECOMIX concrete mixers have the CE marking.
2 — GENERAL SECURITY INSTRUCTIONS
When using this equipment be sure to follow the regulations applied in order to reduce the risk inherent to its usage.
-» Read this Instruction Manual intently.
-» Only use the machine according to the instructions in this manual
-» The operator should be fully trained and qualified to operate this machine.
-» The operator should wear close-fitting clothing; hair tied and should be familiar with the functioning of the machine.
-» Always keep the work zone clean, free of objects and with the necessary illumination.
-» It is forbidden to remove or alter any security device. If any alteration is verified, ALTRAD Group declines any responsibility in eventual
damages to people or objects.
-» Any electronic work should be done by qualified personnel only.
-» Perform the maintenance recommended in this manual and respect its regularity.
-» When cleaning or performing maintenance on the machine; disconnect it from the power supply.
-» Never operate the machine under the influence of alcohol, drugs or medication that might influence physical capacity.
3 – TECHNICAL FEATURES
4 – STARTING-UP INSTRUCTIONS
4.1 – Starting-up
-» Install the concrete mixer in a flat zone with sufficient space to make its load and unload.
ELECTRICAL ENGINE
-» To connect this machine to electricity it is obligatory to:
The energy plug be compatible with the machine connection
The cable used must have three conductors (Phase, Neutral and Land) with a minimum section of 2.5 mm
The net tension should be 230V 50Hz
Have protection against short-circuits of 10A installed in the machines' supply board.
4.2 – Use
1 - Start the concrete mixer by turning the switch on.
st
2 nd - Tilt the drum to the desired angle.
3 - Full the drum with the components to manufacture concrete in the following order:
rd
 ½ of the water  ½ of the sand  All the cement  Remaining sand  Remaining water  Additives
4 - Once the concrete is done, tilt the drum in order to pour the mortar.
th
5 - Turn the switch off once the concrete has been made.
th
Model
Bucket Capacity (L)
Mixing Capacity (L)
Bucket rotation (r/min)
Engine Power (KW)
Electrical Current
Net weight (Kg)
Noise (dB)
Size (mm)
BET ECOMIX 150
140
120
24
0.7
U (V) 220
49
85
1250x1205x670
10
2