Specific Safety Rules - RIDGID JP06101 Manuel D'utilisation

SPECIFIC SAFETY RULES

 PROTECT YOUR LUNGS. Wear a face or dust mask if
the cutting operation is dusty.
 PROTECT YOUR HEARING. Wear hearing protection
during extended periods of operation.
 INSPECT TOOL CORDS PERIODICALLY AND, IF
DAMAGED, HAVE REPAIRED AT YOUR NEAREST AU-
THORIZED SERVICE CENTER. CONSTANTLY STAY
AWARE OF CORD LOCATION. Following this rule will
reduce the risk of electric shock or fire.
 INSPECT FOR AND REMOVE ALL NAILS FROM LUM-
BER BEFORE USING THIS TOOL. Following this rule
will reduce the risk of serious personal injury.
 SAVE THESE INSTRUCTIONS. Refer to them frequently
and use them to instruct others who may use this tool. If
you loan someone this tool, loan them these instructions
also.
 SMALL OR THIN WORKPIECES CAN KICKBACK
WHEN THEY TIP OVER ON THE TABLES OR INTO
THE CUTTER HEAD. To reduce the risk of cutter head
contact or workpiece kickback: Never joint, plane or bevel
workpieces shorter than 12 in.
 WHEN JOINTING never joint workpieces less than
3/4 in. wide or 1/4 in. thick.
 ALWAYS USE PUSH BLOCKS/PUSH STICK when
jointing or beveling wood narrower than 3 in.
 WHEN RABBETING always make cuts in 1/8 in. incre-
ments or less.
 NEVER PLANE WOOD NARROWER OR THINNER
THAN 3/4 IN.
 ALWAYS USE PUSH BLOCKS/PUSH STICK when
planing.
 NEVER perform any operation "freehand" which means
using only your hands to support or guide the workpiece.
Always use either the rip fence or miter fence to position
and guide the work.
 MAKE SURE THERE'S NO DEBRIS between the
workpiece and either the fence or table top.
 ALWAYS USE A STABLE WORK SUPPORT WHEN
JOINTING OR PLANING LONG WORKPIECES. Never
use another person as additional support or to help feed,
support or pull the workpiece in any operation.
 NEVER CUT more than one workpiece at a time.
 NEVER TURN YOUR JOINTER/PLANER "ON" before
clearing everything except the workpiece and related
support devices off the table.
 AVOID AWKWARD OPERATIONS AND HAND POSI-
TIONS where a sudden slip could cause your hand to
move into the cutter head. Never pass either hand over
the cutter head during any operation.
 IF THE POWER SUPPLY CORD IS DAMAGED, it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
 SAVE THESE INSTRUCTIONS. Refer to them frequently
and use to instruct other users. If you loan someone this
tool, loan them these instructions also.
4