Tools Needed - RIDGID JP06101 Manuel D'utilisation

FEATURES
KNOW YOUR JOINTER/PLANER
See Figure 6.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
DUST CHUTE WITH TOOL STORAGE
Allows 4 in. diameter dust collection hose. Easily slides up
and out of the way when a vacuum is not connected. Also
tool storage for knife adjustment wrenches.
OUTFEED TABLE
The section of a jointer bed which supports the workpiece
after it passes over the cutter.
FENCE LOCK KNOB
Allows fence to move across table front to back. This is done
to achieve full width of cut or to use a different (sharper) part
of cutter knives.
PULLEY GUARD
Protects user from incidental access to the motor belt and
pulley.
TABLE LOCK SCREW
Use these screws to lock infeed or outfeed table at a desired
height.
DEPTH OF CUT HANDWHEEL
By turning the handwheel you can control how much wood
will be removed from the workpiece on each cut.
90° AND 135° FENCE STOPS
When adjusted properly, these stops provide a method for
quickly moving the fence to a 90° or 135° position from the
table.

TOOLS NEEDED

The following tools (not included) are needed for making adjustments or installing the knives:
PHILLIPS SCREWDRIVER
STRAIGHT EDGE
FENCE TILT HANDLE
Assists in positioning the fence to various bevel angles.
FENCE
Guides workpiece over cutter head.
BEVEL LOCK HANDLE
Secures the fence at the desired bevel setting.
INFEED TABLE
The section of the jointer bed upon which the workpiece is
placed before being pushed into the cutter. Its height is ad-
justable which allows the operator to select the depth of cut.
CUTTER GUARD
Helps protect the operator from the sharp knives on the cutter
head. It is spring loaded so it automatically keeps the cutter
head covered before, during, and after a cutting operation.
It must always be used.
STOP PIN
For rabbeting operations up to 1/2 in. deep, stop pin can be
pulled out to lower infeed table in 1/8 in. increments.
ANGLE GAUGE
Used to set the fence at the desired bevel angle.
ON/OFF SWITCH
Turns the tool on and off. When the key is inserted in the
switch lever, the power may be turned ON ( I ) andOFF ( O ).
When it is removed, the power cannot be turned ON. This
feature is intended to help prevent any unauthorized use.
ADJUSTABLE WRENCH
COMBINATION WRENCH
(1/2 IN.)
10
COMBINATION
SQUARE
Fig. 7