Handwheel - RIDGID JP06101 Manuel D'utilisation

OPERATION
DEPTH OF CUT HANDWHEEL OPERATION
See Figure 28.
Turning the handwheel clockwise will lower the infeed table.
This will cause more wood to be removed from the workpiece
during the cutting operation.
Turning the handwheel counterclockwise will raise the infeed
table, causing less wood to be removed from the workpiece.
The maximum amount of wood that can be removed during
one cut is 1/8 in.
STOP PIN OPERATION
See Figure 29.
A stop pin is supplied to prevent planing or jointing more than
1/8 in. depth of cut. Planing and jointing operations greater than
1/8 in. per pass are not recommended. Rabbeting operations
greater than 1/8 in. can be performed by pulling the stop pin
out and lowering the infeed table in 1/8 in. increments. The pin
automatically resets when you return to the 0 in. to 1/8 in. depth
of cut range. Never cut a full 1/2 in. rabbet in one cut. Cut in
1/8 in. depth increments until your full depth is acquired.
WARNING:
To avoid serious personal injury never make a
rabbet cut deeper than 1/2 in.
TO RAISE INFEED
TABLE
21

HANDWHEEL

TO LOWER
INFEED TABLE
Fig. 28
STOP
PIN
Fig. 29