Filling The Chemical Agent Tank (Optional); Operation; Checks Before Use; Preparing The Machine And Choosing The Cycle - Ghibli & Wirbel ROUND 45 TOUCH Utilisation Et Entretien

- Turn on the tap and fill the tank (5) to the
MAXIMUM LEVEL (NOT EXCEED) indi-
cated by the label placed on the transpar-
ent tube (15).
- Pour the detergent fluid in the tank.
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
9.2 FILLING THE CHEMICAL
AGENT TANK (optional)
(Fig. 6-12)
WARNING:
MAKE SURE THAT THE RECOVERY
TANK IS EMPTY.
- Press the button (36 Fig. 6) and lift the
tank (14 Fig. 6) until complete overturn-
ing.
- Release the lock (74 Fig. 12) and remove
the cap (75 Fig. 12) of the tank (76 Fig.
12).
- Place the suction tube (77 Fig. 12) and
close the tank with the cap.
- Lower the tank (14 Fig. 6) until you hear
a coupling "Click".
DANGER:
In case the chemical agent gets in contact
with eyes and skin or in case of ingestion
please refer to the Safety data sheet and
the instructions of use of the chemical
agent manufacturer.
10.1 OPERATION (Fig. 1-9)
10.1.a - Checks before use
- Check that the exhaust tube (12) of the
recovery tank is properly coupled and
properly sealed.
- Check that the connector (54) on the
squeegee (11) is not blocked and that the
hose is connected correctly.
- Check that the clean water exhaust tube
(15) is correctly coupled to the supports
and that the tap (53) is open.
- Press the button (45) and check the bat-
tery charge state on the display.
- Check if in the chemical agent tank (op-
tional) is enough product for the daily
needs.
10.1.b - Preparing the machine and
choosing the cycle (Fig. 9-13)
- Press the button (45 Fig.9), the display
(46 Fig.9) lights up, indicating the battery
charge status.
- Release the lever (3 Fig. 13) and lower
it; the floor squeegee (11 Fig. 13) is low-
ered.
- Press the pedal (19 Fig. 13), disengage
it from its lodging and lift it: the brush/
brushes (10 Fig. 1) will be lowered.
NOTE:
The brush has two working positions;
Normal position "A"
It is automatically placed when you release
the pedal (19 Fig. 13) from the lifted position.
Position for persistent dirt "B"
From the "A" working position, lift the pedal
(19 Fig. 13) and engage it in the "B1" holder;
an additional pressure of 5 kg will be exer-
cised on the brush.
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform only the drying cycle, press
the button (50 Fig. 9), the aspirator will
start.
ENGLISH - 12
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968