Rear Panel - HK Audio PREMIUM PR:O MOVE 8 Manuel

MOVE 8 1.1

2.2 Rear Panel

15
In
Aux
16
Out
19
Service
20 VDC / 3.25 A
20
DC In
B
Green LED on:
Charging
complete
●
15
Aux In
Use this stereo mini jack to patch in a stereo line signal, for instance, from a
multimedia player, mixing console or keyboard (with an appropriate cable).
The Channel 4 Volume knob adjusts this input's level.
●
16
Aux Out
Use this stereo mini jack to patch out the summed stereo signal. The
Master Volume knob controls this signal's level.
●
17
Footswitch Rev Mute
This 1/4" (6.3 mm) jack accepts a standard one-way footswitch serving to
switch the internal Reverb on and off . It is a very convenient tool for muting
the eff ect, for instance, for announcements.
●
18
FX CH 3 (Send/Return)
These unbalanced 1/4" (6.3 mm) jacks serve to connect an eff ects unit. This
serial eff ects loop sends the signals from Channel 3 through an external
eff ect device. To this end, connect MOVE 8's FX Send to the eff ects unit's
input and the eff ects unit's output to MOVE 8's FX Return. Set the wet/
dry mix – that is, the relative amount of source and eff ect signals – on the
external eff ects unit.
●
19
Service
This USB interface is there strictly for service purposes.
Caution: Do not use this port to charge mobile devices, smartphones or
tablets! Please do not connect devices of any kind to it.
6
Footswitch
17
Rev Mute
18
FX
Return
CH 3
Send
21
Power
22
Battery
A
100%
Green
60%
Yellow
LED off:
30%
No Battery
Red
detected
0%
●
20
DC In
The included external power supply unit's cord connects to this socket.
●
21
Power
This button switches MOVE 8 on and off . The Power LED lights up green
when the device is on. To switch MOVE 8 off , press the Power button for
around three seconds until the LED extinguishes.
●
22
Battery B / A
This LED indicates the two batteries' state of charge. See the next section,
Operating MOVE 8 on Battery Power, for more on this.