Setting The Operating Mode - Niko 10-845 Information De Produit

10-845
10.1. Starting the programming
Authorization via IR remote control With each push on the key, the device sounds a short key confirmation tone.
Enter master code
Programming possible
Wrong entry,
master code unknown
No code entered

10.2. Setting the operating mode

Start the programming
Enter the operating mode
Operating mode is set
Invalid value
10.3. Setting serial number of internal units
Start the programming
Enter serial number
Set serial number
Set more serial numbers
invalid value
already 32 SNs saved
SN 1 is already programmed
* For the programming of the screen memory, it doesn't matter whether the serial numbers are all programmed on one bell push button of the external unit, or
that the internal video unit was assigned to other internal video units via a parallel connection.
10.4. Deleting serial number of the internal unit
Start the programming
Enter serial number
52
The yellow LED is off.
*Master code # (FI= 6-digit serial number of the 10-845)
A confirmation signal sounds. LED lights up yellow during 3 sec. After, the
yellow LED flashes.
If you press #, a negative confirmation tone sounds. The yellow LED flashes
rapidly during 3 sec. and then switches off.
You can enter the wrong code three times. After, the code entering function
will be blocked for 2 minutes. You can no longer enter a code. The yellow LED
is on during 2 min and then switches off. Start again.
If after 2 min. no command has been entered, the device will automatically
terminate the programming mode. The LED switches off.
If not already done.
*0 # operating mode # (FI=0)
= 0 EFH mode
= 1 basic mode or
= 2 comfort mode
= 3 comfort-simplex mode
A confirmation signal sounds. LED lights up yellow during 3 sec. After, the
yellow LED flashes.
If you press #, a negative confirmation tone sounds. The yellow LED flashes
rapidly during 3 sec. and then flashes again.
If not already done.
*1 # SN 1 # SN 2 #
up to 32 pairs of numbers can be programmed*
always SN 2 = 0 if only SN 1 must be programmed
A positive confirmation signal sounds. LED lights up yellow during 3 sec. After,
the yellow LED flashes again.
On the SD card, a folder is made on which a log is saved.
Repeat the aforementioned steps.
If you press #, a negative confirmation tone sounds. The yellow LED flashes
rapidly during 3 sec. and then flashes again.
If not already done.
*3 # SN 1 #
Log with SN 1 is deleted. Up to 32 pairs of numbers can be programmed.
Always enter SN 2 = 0 if only SN 1 must be pro-grammed.
0 9
0
1
3
EN