Elem Garden Technic FBV3000-7TEGCW Traduction Des Instructions D'origine page 52

Editing:
WARNING
Risk of injury!
Place the device horizontally on a flat surface,
and stable enough carrier.
WARNING
Risk of injury!
The installation should be done with the help of
another person.
WARNING
Risk of injury!
Improperly installed parts may at
the use of the device, cause
severe injury! This device has only the right to
be placed in service if all parts are fully and
correctly installed and if no room is
damaged!
- Please first read the entire chapter before
installing the parts!
- Assemble all parts thoroughly.
watch out
Damage to the machine!
The unit comes with hydraulic oil in the tank.
The activation of the device with too little oil
causes damage to the engine.
Mounting wheels
- Place the unit carefully so
the splitter is facing
up.
- Insert the wheel (10) about the axis (A).
- Insert the pin (B)
into the two holes of the axis (A) and bend
ends.
- Do the same on the other
side.
Mounting handles
- Insert the sheet of hand protection
on the upper left side of the apparatus.
- Insert a long oval head screws
and square neck (A) from above in
and the unit in the protection sheet
hands.
- Secure the long truss screws and collar
square (A) with the bottom of the nut
blocking (B).
- Do the same on the other
side.
Note:
Make sure that the lever
actuating means (6) is inserted through the
slot (C)
Note:
The plates of the hands (5)
for the left and right sides are
must not be reversed. screw
for fixing the actuating lever (6)
should be facing outward. the
fixing hole fastening plates
Trunk (4) must be turned
above.
Note:
The truss screws and square neck
and locknuts must
not be tightened too tightly.
The plates of the hands (5)
and the levers (6)
must be able to move freely.
Mounting the front handle
- Mount the front handles (7) using
screw (B) on the cover plate of
hands (5) left and right.
Mounting the trunk
WARNING
Risk of injury!
The trunk support (8) is to be
fully pushed in
hanger (A).
- Insert the trunk (8) in the
suspension devices (A).
- Turn the locking lever (B) on both sides
downwardly.
Note:
The trunk support (8) can be
mounted at three different heights.
Establishment
- Place the camera on a flat surface and
strong enough.
- Connect the equipment into an outlet
Security.
- Make sure there is a gap of more
one meter above the apparatus.
- Check the direction of motor rotation
before each use and adjust it if
necessary.
52