Lupine Betty R Manuel D'utilisation page 37

Note: The battery time remaining after the green or red LED backlight turned on depends on total
battery capacity, the ambient temperature, the battery's age, and which setting is used. Moreover,
since the voltage curve of a Li-Ion battery is not proportional to the power left in the battery, you
need to learn how to interpret the relevant displays for your specific battery.
Empty battery and reserve power:
When the battery is completely discharged (all 5 red LEDs blink with a red
backlight on), the light will shut down after flashing a few times!
To activate the battery's reserve power, doubleclick the switch. This will
give you a few minutes more light, whose exact amount depends on the
age of your battery. The light emitted in reserve-power mode is a very low
beam so as to conserve power and keep the light going as long as possible.
The red 5 LEDs slowly flash when reservepower mode is activated and
the backlight will be red.
discharged, the light will shut down – which means that you to slow down.
Note: If only 2.0 W or less was used, reserve power is not available!
Safety advisory:
is discharged, as this will invariably
Recharge the battery as soon as possible to avoid a deep
discharged battery.
Safety advisory: When the battery is completely discharged ( all 5 red LEDs blink
with a red backlight on), the light will shut down after flashing a few times. In such
a case, you should stop riding your bicycle immediately.
When the reserve power has been completely
Do not switch on the light when the battery
damage the battery.
Battery empty
5 red LEDs blinking
Backlight red
Backlight blinks
red/blue
Betty R 37
3