Table des Matières
Publicité
2
1
a
a
b
1
FWD
a
1
Set up point
• Handlebar (For FX10)
1. Loosen the bolts 1.
2. Raise the handlebar 2 as shown in the illustration and
align the punch mark a on the handlebar with the upper
surface of the lower handlebar holder.
3. Tighten the bolts.
CAUTION:
First tighten the bolt on the front side, and then tighten
the bolt on the rear side.
For FX10RT/FX10RTR/FX10RTRA/FX10MT/FX10MTR/
FX10MTRA
1. Install the handlebar 1.
1
CAUTION:
2
First tighten the bolt on the front side, and then tighten
the bolt on the rear side.
NOTE:
• The handlebar holders 2 should be installed with the
punch mark a facing forward.
• Align the punch mark b on the handlebar with the upper
surface of the steering joint.
• Wind deflector (For FX10/FX10RT/FX10RTR/
FX10RTRA)
1. Install the wind deflector stay holder 1 with the taller end
facing forward.
2. Align the punch mark a on the handlebar with the top of
the wind deflector stay 1.
1
• Handlebar cover (For FX10/FX10RT/FX10RTR/
FX10RTRA/FX10MTRA)
1. Install the handlebar cover 1, making sure not to pinch
the cables, leads, etc.
NOTE:
Adjust the throttle cable after installing the handlebar cover.
Refer to "THROTTLE CABLE ADJUSTMENT".
2-9
Publicité
Table des Matières
