Energy Saving Tips - Danby DAC6010E Guide D'utilisation Et Soins De Propriètaire

ENERGY- Your Danby appliance is designed to be highly efficient in energy savings.
Follow these recommendations for greater efficiency.
SAVING TIPS
1) Select a thermostat setting that suits your comfort
needs and leave at that chosen setting.
2) The filter is very efficient in removing airborne
particles. Keep the air filter clean. Normally,
filters should be cleaned every 2 weeks. More
frequent cleaning may be necessary depending on
indoor air quality.
3) Use drapes, curtains or shades to keep direct
sunlight from penetrating and heating room, but
do not allow drapes or curtains to obstruct the air
flow around the unit.
ELECTRIC SHOCK HAZARD: To avoid the possibility of personal injury, disconnect power to the
unit before installing or servicing.
TOOLS NEEDED FOR INSTALLATION:
Screw Drivers: Both Phillips and flat head
Power Drill: 1/8 inch (3.2mm) diameter drill bit
Pencil Scissors
Measuring Tape Carpenters Level
Your Room Air Conditioner is designed for easy installtion in a
single or double-hung window. This unit is NOT designed for
vertical (slider type) windows and/or through-the-wall applications.
NOTE: Save the shipping carton and packing materials for future
storage or transport of the unit. From carton, remove the plastic bag
containing the installation hardware kit necessary for the installation
of your air conditioner. Please check the contents of hardware kit
against the corresponding model check list, prior to installation of
the unit. See Fig. 1.
CAUTION: Because the compressor is located on the controls
side of the unit (left side), this side will be heavier and more
awkward to manipulate. Inadequate support on control side of the
unit can result in personal injury and damage to your unit and
property. Therefore, it is recommended that you have someone assist
you during the installation of this unit.
NOTE: Your unit is designed to evaporate condensation under normal conditions. However, under
extreme humidity conditions, excess condensation may cause basepan to overflow to the outside. The unit
should be installed where condensation run-off cannot drip on pedestrains or neighboring properties
IMPORTANT SAFETY INFORMATION
INSTALLATION
4) Start your air conditioner before the outdoor air
becomes hot and uncomfortable, to avoid an initial
period of discomfort while the unit is cooling off
the room.
5) When outdoor temperatures are cool enough, use
HIGH or LOW FAN only. This circulates indoor
air, providing some cooling comfort, and utilizes
less electricity than when operating on a cooling
setting.
INSTALLATION HARDWARE
3/8" (9.5mm) screws
(4) (*Factory installed
on some models)
Fig. 1
3
3/4" (19.1mm) Safety Lock (1)
screws (9)
"L" Shaped
mounting
bracket (1)
*Factory installed
on some models
Sash bracket (2)
Adhesive
Foam Seal(1)
Side Curtain RH (1)
Side Curtain LH (1)