Energy Saving Tips; Installation; Mounting Hardware - Danby DAC10000 Guide D'utilisation Et Soins De Propriètaire

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: Read these instructions carefully before operating the unit.

ENERGY SAVING TIPS

Installation Instructions
ELECTRIC SHOCK HAZARD
To avoid the possibility of personal
injury, disconnect power to the unit
before installing or servicing.
NOTE: Your air conditioner is designed
for installation in a standard double hung
window with an opening width of 22 to 36
inches (550 mm to 914 mm) (FIG. 1)
Fig. 1
EXTERIOR
OFFSET
WALL
STOOL
15 8/16"
SILL
(394mm)
INTERIOR
WALL
Your Danby appliance is designed to be highly efficient in energy
savings. Follow these recommendations for greater efficiency.
1) Select a thermostat setting that suits your comfort needs and leave at
that chosen setting.
2) The air filter is very efficient in removing airborne particles. Keep the air
filter clean at all times. (usually cleaned every 2 weeks depending on
indoor air quality).
3) Use drapes, curtains or shades to keep direct sunlight from penetrating
and heating the room, but do not allow drapes or curtains to obstruct
the air flow around the unit.
4) Start your air conditioner before the outdoor air becomes hot and
uncomfortable, to avoid an initial period of discomfort while the unit is
cooling off the room.
5) When outdoor temperatures are cool enough, use HIGH or LOW FAN
only. This circulates indoor air, providing some cooling comfort, and
utilizes less electricity than when operating on a cooling setting.
Lower sash must open sufficiently to allow a clear vertical opening of 15
8/16 inches (394 mm). Side louvers and the rear of the AC must have
clear air space to allow enough airflow through the condenser, for heat
removal. The rear of the unit must be outdoors, not inside a building or
garage.
NOTE: SAVE CARTON and these INSTALLATION INSTRUCTIONS for
future reference. The carton is the best way to store unit during winter, or
when not in use.
Some assembly is required. Please read these instructions
carefully.
22" to 36"
550mm to 914mm

MOUNTING HARDWARE

3/4"screws
Lock Frame
Sash Lock
4
QUANTITY
6
2
1