Selve i-R Light Sensor Notice D'utilisation page 30

GB
Explanation of functions/terms used
TEST MODE
This mode is used to test the i-R Light Sensor. In TEST MODE,
the times for the sunshade function are reduced from minutes to
seconds.
Press the manual/automatic button until the control light flashes
green 3 times. The TEST MODE will remain active for 5 mins.
Manual/automatic button
The manual/automatic button can be used to deactivate auto-
matic control commands (e. g. sun protection function, twilight
function).
When the system is set to manual mode, the control will light up
briefly in red.
When the system is set to automatic mode, the control light will
light up briefly in green.
Control light
If a control command is executed, the control light will light up
briefly to signalise this.
Green: UP
Red: STOP
Yellow: DOWN
If the battery starts running out, the control light flashes during
transmission.
The transmitter power and/or radio range is reduced when the
battery is running low. If the control light is no longer lit when the
button is pressed, the batteries must be changed.
30