Faulty Or Lost - Selve i-R Light Sensor Notice D'utilisation

GB
Transmitter programming procedure
3.) Reprogramming if a transmitter is faulty or lost
If a learnt transmitter is no longer available (due to loss or a fault),
proceed as follows:
Important: Please ensure that all receivers connected to the
subdistribution are put into reprogramming mode at the same
time by disconnecting the supply as above. If you then activate
the PROG button for 3 seconds, the new transmitter will
be learnt into all receivers in reprogramming mode.
darauf, dass beim Anschluss eines fest installierten Schalters,
dieser nicht auf Position AUF oder AB steht.
Note: The reprogramming mode is ended using a control com-
mand from a transmitter that has been learnt. If reprogramming
mode has been carried out successfully, all previous transmitters
will have been unlearnt are deleted. Only the newly programmed
transmitter is active (safety function).
Disconnect from the power supply
disconnect
from the
supply for
3 seconds
The receiver acknowledges this reprogramming mode by means
of a brief upwards and downwards movement of the drive.
Empfänger befinden sich jetzt im Servicemodus.
Within approx. 4 minutes, press the PROG button for
the new transmitter for 3 seconds (wait until the trans-
mitter control light flashes once).
The new transmitter is now learnt into the receiver.
connect disconnect
to the from the
supply for supply for
3 seconds 3 seconds
34
Achten Sie
connect
to the supply
Die