Utility Setup - Lupus Electronics Aeon LE800 Manuel Utilisateur

Item
SPOT MODE
Interval (Seconds)
Skip Video Loss Channel

5.10 Utility Setup

Item
HDD Initialization
USB Initialization
System Recovery
Reset System Events
Copy Setup to USB
Download Setup from USB
Upgrade
Channels display in spot for three different modes:
MANUAL:
Select channels to display manually, select channels will
be transfered to the SPOT monitor.
SEQUENCE: Auto-sequence for all channels in order.
EVENT:
Display channels with event occurred.
The duration interval time between channels is in seconds under SPOT
mode (can not be set to 0 seconds).
Whether to skip channels without video signal.
Select to enter hard disk initialization menu. Please stop recording
before entering this menu. Enter the menu, system will show all the
data (model/ volume) of HDD that is installed in the DVR. Check the HDD
you'd like to initialize, then press "Start". HDD initialization is successful
when the status shows "Succeed".
Clean up all data on USB. Enter USB initialization and press "YES" to
clean up all data on your USB. The initialization is done when it shows
"Succeed".
Restore system default values.
Reset all the recording events in the DVR.
Copy configuration to a USB device. There will be a file named
"sdvr.config" on your USB.
Download configuration from a USB device into DVR.
Upgrade DVR through USB.
Please stop recording and backup setup configuration before upgrading.
System will reboot automatically when the upgrade is completed.
37
Description
Description