Connecting The Power Cord; Preparing The Remote Control; Installing Batteries In The Remote Control - Samsung DVD-VR375 Manuel D'utilisation

getting started

Connecting the Power Cord

After all connections are complete, plug the power cord into a wall outlet.
"Auto" appears in the panel display. This means that the current time is being set automatically (Auto
Program) through the antenna under connection and also the channel is being set. The setup may take a few
minutes.
When the DVD Recorder operates normally, the current time is automatically set and displayed in the front
panel display.
M

After the current time is set automatically, the recorder will perform Auto Preset for about 3 minutes. If power is on
before fi nishing the Auto Preset process, Auto Preset will stop. In this case, do Auto Preset from MENU. (See page
31)

Preparing the Remote Control

Installing batteries in the Remote Control

1. Lift the cover at the back of the
remote control upward as shown.
If the remote control does not operate properly:
•
Check the polarity +/- of the batteries.
•
Check if the batteries are drained.
•
Check if the remote sensor is blocked by obstacles.
•
Check if there is any fl uorescent lighting nearby.
Dispose of batteries according to local environmental regulations.
Do not put them in the household trash.
14_ getting started
2. Install two AAA size batteries.
Make sure to match the "+" and "–"
ends of the batteries with the diagram
inside the compartment.
3. Replace the cover.
Assuming typical TV usage,
the batteries last for about
one year.