Troubleshooting - Panasonic ER‑GY60 Mode D'emploi

Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
(See page 17.)
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
►
Replacement parts
Replacement part is available at your dealer or Service
Centre.
Blade
Replacement parts for
ER‑GY60
Lubrication oil WES003P
• Do not use any blade other than the one dedicated as
it may cause defect in performance.
• We recommend Panasonic lubrication oil WES003P.
18

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the
store where you purchased the unit or a service
centre authorized by Panasonic for repair.
Problem
The main body
has become
WER9500
blunt.
Operating time
is short.
Main body
stopped
functioning.
Action
Until problems are solved, please
follow each procedure as follows:
1. Charge the main body.
(See page 11.)
2. Clean the blade and apply oil.
(See pages 16‑18.)
3. Replace the blade.
(See page 17.)
4. Have the battery replaced by an
authorized service centre.
Charge the battery for
approximately 8 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)
Contact an authorized service
centre for repair.