FYTTER Runner RU-09B Mode D'emploi page 49

ERROR
POSSIBLE CAUSES
CODE
E1 Defection on speed sensor.
E2 Overload or over voltage protected.
E3 Over current protected
E4 Defection on motor
Defection on the cables between
E6
computer and controller
E7 Safety key off
Error on controller proofreading with
E0P
motor.
CORRECTION
Check whether the speed sensor is installed well,
whether the sensor is broken, and whether the
distance between sensor and roller is in 3-5MM.
Switch off the power and switch on the power again.
Switch off the power and switch on the power again.
1. Check cable connection between motor and
controller.
2. Check whether the motor is broken.
Check whether the upright cables are well-connected;
Attached the safety key correctly.
Contact your dealers to solve the problem
FYTTER |WWW.FYTTER.COM PAG- 48