Opc Lock-Out (T-Handle); Clutch; 3.10 Handle - Jacobsen Greens King 500A Série Mode D'emploi

3.8

OPC LOCK-OUT (T-HANDLE) ________________________________________________

Adjust screw (R) so that the OPC bail (T) stops shortly
after OPC lock out lever (S) engages the OPC bail.
3.9

CLUTCH _________________________________________________________________

Adjust stop screw (V) until clutch fingers are (.06 -
touching) the throw out bearing. Lock jam nut.
Pull clutch cable until OPC bail is against the stop.
The OPC Lock Out lever on T-handle units must be
properly adjusted before clutch is adjusted. (See Section
3.8)
Pin (U) should be against end of the bolt. Spring should
measure 1-13/16 in.,
disengaged. With the clutch fully engaged, the spring
should compress to 1-3/4 in., (44 mm).

3.10 HANDLE _________________________________________________________________

1. To adjust the angle of the handle bar (Y), loosen
screw (W) on both sides of the mower and adjust the
handle bar to the desired position.
2. After adjusting handle bar, adjust bracket (X) so that
the handle bar just rests on the bottom of the slot in
bracket. Tighten screw (W).
(46 mm) with the
R
U
V
clutch
ADJUSTMENTS
S
Figure 3G
1-13/16" (46 mm) disengaged
1-3/4" (44 mm) engaged
Figure 3H
Y
X
W
Figure 3I
3
T
GB-11