Using Your Ceiling Fan - Emerson BUILDER CF700BS09 Manuel Du Propriétaire

BP7312-4 CF700.qxp_ BP7312 2/27/15 5:14 PM Page 16
6.1
Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
Check the operation of the fan by gently pulling on the
pull chain switch.
All fans are shipped from the factory with the reversing
switch positioned to the "left" circulate air downward.
If airflow is desired in opposite direction, turn your fan
OFF and wait for the blades to stop turning, then slide
the reversing switch to the "right" position, and turn fan
on again (Figure 22).
The fan blades will turn in the opposite direction and
reverse the airflow.
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise
6.2
Cut the 3-speed switch pull chain to a desired length
(optional). Connect the wood pendant (supplied) to the
3-speed switch pull chain by sliding the wooden
pendant (small hole first) onto the pull chain
(Figure 23). Attach the chain coupler to the end of the
chain and allow the wooden pendant to fall down over
the coupling.
Your fan model is equipped with a 4-position,
3-speed pull chain switch (Figure 23). The operating
sequence is as follows:
Three-Speed
1st Pull—HIGH
2nd Pull—Medium
3rd Pull—Low
4th Pull—OFF

6. Using Your Ceiling Fan

Switch Position
Left
Right
16
REVERSING
SWITCH
Figure 22
WARNING
!
To reduce the risk of fire or electrical shock, do not
use this fan with any solid-state speed control device.
3-SPEED SWITCH
PULL CHAIN
Figure 23
SWITCH
HOUSING
ASSEMBLY
CHAIN COUPLER
WOODEN PENDANT
U.L. Model No.: 52-ANT